Adventure in Creating
For now I cut the damaged kinked part out of the harness and used crimp connector splices to splice in some 16 gauge wire and placed the protective cover back over it. There will be some redesigning of the harness. I also for now used the drag chain as a support and extended it with some zip ties its now working for a day already so we are back to printing
One of the problems with the way the Bondtech extruder is mounted that on some occasions the PTFE tube will pop out and filament will feed all over the place. To avoid that print this
PTFE Tube Holder for Bondtech QR
Mount it instead of the “C” Clip and tighten with 2 m3 screws and lock nuts. Depending on your printer you might have to be careful to not crush the PTFE tube
The wires in the harness broke due to the harness kinking when going back and forth Anycubic is going to replace it but in the meantime we are ordering parts to do so ourselves the connectors as per Alexander Djupsjöbacka on the Anycubic Chiron FB forum is
This is for the red plug
The blue one is a 5p I think